Dynalink WLG25USB Guia de Configuração descarregar pdf (Página 7)

WLAN USB Adaptor Quick Set-up Guide

Other network settings

4.1 WEP

If the network you wish to join is WEP enabled, you will have to configure for

WEP. The WEP setting is already determined on the network by the network

administrator. Before you start you should have obtained:

1. The type of encryption, 64 or 128-bit.

2. The encryption keys.

3. The key number to be used.

4. Open or shared key authentication.

The settings must be identical to those entered into the access point.

From the Site Survey page

of the RaConfig utility,

highlight the access point

you wish to joint and click

Connect. You will be asked

to enter the WEP key:

Click OK and the wireless

adaptor will attempt to

connect.

4.2 NETWORK WITH HIDDEN SSID

If the wireless network you wish to join does not broadcast its SSID, you will be

asked to supply the SSID. If the SSID entered does not match the one in use, it

is up to the access point to decline or accept the connection request.

Adding extra security by MAC address filtering

Some access points may use this option to provide an extra level of security. The

MAC address, or the unique hardware ID of your wireless adaptor is pre-registered

with the access point. If the network uses this function, you must supply the

MAC address of your adaptor to the network administrator for inclusion into the

access point. The MAC address of your adaptor is printed on a barcode label

affixed to the product. Refer to Question 2 of the Troubleshooting section if you

cannot locate the MAC address of your adaptor.

1 2 3 4 5 6 7 8 9 10

Sem comentários

Dynalink WLG25USB Guia de Configuração Página 7